Ranger 2WD L4-140 2.3L SOHC (1984)
Universal Joint: Service and Repair
Cross & Roller Type
With Replacement Tool
Fig. 7 Removing bearing caps using tool & adapter
Fig. 8 Removing bearing cap by holding cap in vise & striking center yoke with hammer
Disassembly
1.
Place driveshaft in a vise using care to avoid damaging it.
2.
Remove bearing retaining snap rings. Some universal joints use injected nylon retainers in place of snap rings. During servicing, the snap rings
supplied with the replacement universal joint assembly must be used.
3.
Position tool on shaft and press bearing out of yoke, Fig. 7. If bearing cannot be pressed all the way out, remove it using vise grips or channel lock