Ranger 2WD L4-153 2.5L SOHC VIN C SFI (1998)
Crankshaft Position Sensor: Service and Repair
REMOVAL
1. Disconnect the battery ground cable.
2. Drain the cooling system.
3. Remove the drive belt.
4. Remove the bolts and position the Generator (GEN) out of the way.
5. Remove the lower radiator hose from the water pump inlet tube.
6. Remove the heater water hose from the water pump inlet tube.
7. Remove the bolts and the water pump inlet tube.
8. Remove the O-ring from the water pump inlet tube.
9. Disconnect the Crankshaft Position sensor (CKP sensor).
10. Remove the screw.