Ranger 2WD L4-153 2.5L SOHC VIN C SFI (1998)
Fluid Filter - A/T: Service and Repair
REMOVAL
1. Raise and support the vehicle.
2. Place a drain pan under the transmission fluid pan.
3. Drain transmission fluid.
NOTE: Transmission modulator heat shield does not have to be removed from vehicle for fluid pan removal.
-
Remove all the screws except for two in the front. Loosen the two screws. Pry the rear of the transmission fluid pan down and allow fluid to
drain. After fluid is drained remove the two remaining screws.
4. Remove the transmission fluid pan.
1. Remove the transmission fluid pan.
2. Remove and discard the transmission fluid pan gasket.
5. Remove and discard the transmission fluid filter.
1. Remove the screw.
2. Remove the transmission fluid filter.