Ranger 2WD L4-153 2.5L SOHC VIN C SFI (1998)
5. Install the (RH) transmission mount bolt.
1. Position the exhaust bracket.
2. Install the bolt.
6. Install the crossmember.
1. Position the crossmember.
2. Install the six bolts and nuts (three each side).
7. Remove Hi-Lift Jack.
8. Install the nuts.
9. Install the rear driveshaft.
1. Position the rear driveshaft.
2. Install the four bolts.
NOTE: To maintain initial driveshaft balance, align marks on the rear driveshaft centering socket yoke and rear axle universal joint flange made
during removal.