Ranger 2WD V6-182 3.0L (1995)
Cruise Control Switch: Testing and Inspection
NOTE: To test speed control actuator switch, perform the following voltage and resistance measurements.
Speed Control Switch Assembly Voltage Specifications.
For voltage measurements, remove 14401 harness connector from speed control servo, then connect negative lead of voltmeter to Pin 10 (circuit
676 PK/O) of connector. Measure DC or AC voltage of circuits listed with positive lead of meter.
Speed Control Actuator Switch Resistance Measurements.
For resistance measurements, remove 14401 harness connector at speed control servo, then connect an ohmmeter between the designated circuits
with ignition switch off.