Ranger 2WD V6-182 3.0L (1995)
Electronic Brake Control Module: Service and Repair
Rear Antilock Brake System (RABS)
Control Module
REMOVAL
1. Remove the instrument panel finish panel.
2. Remove the anti-lock electronic control module-to-instrument panel brace screw.
3. Slide the anti-lock electronic control module to release the upper tab from the instrument panel brace.
4. Disconnect the wiring harness from the anti-lock electronic control unit by depressing the plastic tab on the connector and pulling the connector
off.
5. Remove the anti-lock electronic control module.
6. To install, reverse the removal procedure.