Ranger 2WD V6-245 4.0L VIN X SFI (1997)
both ends of the push rods. Install the push rods in the same locations as removed.
7. Install the intake manifolds.
8. Install the rocker arm shaft assemblies. Tighten the rocker arm stand bolts evenly and in sequence to 6-8 Nm (53-71 inch lbs.).
9. Install the valve covers.
10. Install the engine front cover as an assembly.
11. Install the oil pump drive, hold-down clamp and screw.
View Of Camshaft Damper After Marking Damper
12. After performing Steps 1-11 above, rotate crankshaft until TDC mark on the damper is accessible. If not present, place an additional mark on the
damper at 26 degrees After Top Dead Center (ATDC). This position is 34 mm (1.34 inches) counterclockwise from the Top Dead Center (TDC)
mark.
13. Position No. 1 cylinder to TOG between compression and ignition stroke. (Both intake and exhaust valves must be closed with TDC mark on
vibration damper at pointer.)