Ranger 2WD V6-245 4.0L VIN X SFI (1997)
27. Tighten the CID sensor hold-down bolt to 17-21 Nm (13-15 ft. lbs.) using Sensor Adjusting Wrench T94T-12270-A.
28. Disconnect the testing wiring harness and the voltmeter and proceed.
29. Install oil pan.
30. Install engine front cover.
31. Install engine.
32. Fill the cooling system to the proper level with the specified coolant and bleed the cooling system.
33. Fill the crankcase with the specified quantity and grade of oil.
34. Connect the battery ground cable to the battery.
NOTE: When the battery has been disconnected and reconnected, some abnormal drive symptoms may occur while the powertrain control
module (PCM) relearns its adaptive strategy. The vehicle may need to be driven 16 km (10 miles) or more to relearn the strategy.
35. Run the engine at fast idle speed and check for coolant, fuel, vacuum and oil leaks.
