Ranger 2WD V6-245 4.0L VIN X SFI (1997)
Oil Level Sensor: Service and Repair
REMOVAL
1. With engine off, drain at least 1.9 liters (2 quarts) of oil from engine.
2. Disconnect electrical connection.
3. Remove low oil level sensor with a 26 mm (1-inch) socket or end wrench. Discard old gasket.
INSTALLATION
1. Install new gasket onto low oil level sensor, noting flange faces sensor and the words "pan side" are facing the oil pan.
NOTE: Always replace gasket when removing low oil level sensor.
2. Install low oil level sensor and gasket assembly. Tighten to 20-34 Nm (15-25 ft. lbs.).
NOTE: When replacing low oil level sensor using a metal gasket with a rubber O-ring, tighten sensor to 17-27 Nm (13-20 ft. lbs.).
3. Connect electrical connection.
4. Refill crankcase to correct level.
5. Start engine and check for oil leaks.