Ranger 2WD V6-245 4.0L VIN X SFI (1997)
A/C Clutch Field Coil: Service and Repair
SPECIAL SERVICE TOOL(S) REQUIRED
NOTE: The A/C clutch field coil is pressed on the front head of the compressor. Special service tools are required to remove and install the A/C clutch
field coil.
Shaft Protector For Coil Removal
Shaft Seal Protector
Differential Side Bearing Puller
Coil Pressing Tool
Field Coil Replacer
REMOVAL
1. Remove the A/C compressor from the vehicle following the recommended service procedure.
2. Remove the clutch hub and pulley. Note the location of coil electrical connection for proper orientation during compressor clutch coil installation.
3. Install Shaft Protector for Coil Remover T89P-19623-FH on the nose opening of the A/C compressor.
4. Install a Differential Side Bearing Puller T77F-4220-B1 or equivalent on the compressor. Place the tip of the puller forcing screw in the center
pilot of the shaft protector and the jaws of the puller around the back edge of the A/C clutch field coil.