Ranger 2WD V6-245 4.0L VIN X SFI (1997)
Part 2 Of 2
6. Install the front disc brake hub and rotor on the front wheel spindle.
NOTE: While installing front disc brake hub and rotor keep the hub centered on the front wheel spindle to prevent damage to the retainer and the
front wheel spindle threads.
7. Install the front wheel bearing assembly and flatwasher on the front wheel spindle.
8. Install the adjusting nut. Adjust wheel bearing.
9. Install retainer, new cotter pin, and grease cap.
10. Install the front disc brake caliper to the front wheel spindle.
11. Install the wheel and tire.
12. Lower the vehicle and tighten the lugnuts to 135 Nm (100 ft. lbs.). Install the wheelcover.
WARNING: RETIGHTEN WHEEL LUGNUTS TO SPECIFICATION AT 800 KM (500 MILES). FAILURE TO RETIGHTEN
LUGNUTS AT MILEAGES SPECIFIED COULD ALLOW THE WHEEL TO COME OFF WHILE THE VEHICLE IS IN MOTION,
POSSIBLY CAUSING LOSS OF VEHICLE CONTROL OR COLLISION.
13. Before driving the vehicle, pump the brake pedal several times to restore normal brake pedal travel.
