Ranger 2WD V6-3.0L (2008)
3. With window in down position, remove the top and bottom center door glass Run retainer nuts and push door glass Run A to the side. (Figure 2)
4. Rework the upper glass Run attachment slot. (Figure 2)
a. Remove approximately 5/64" (2 mm) of material at W and 25/64" (10 mm) at H.
b. Remove material from the front of vehicle side of the slot. Be careful to not leave burrs on the panel.
c. Coat newly exposed metal areas with Motorcraft(R) Anti-Corrosion Coating.
5. Reposition glass Run A and loosely attach fasteners.
6. Raise glass to full up position. While pushing outward on the lower attachment. Torque glass Run attachment nuts, tighten to 106 lb-in. (12 N.m). Be
careful not to force a different position of the stud when installing the upper nut.
7. Install trim panel following WSM, Section 501-05-1.
Parts Block
WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage
IMPORTANT: Warranty coverage limits/policies are not altered by a TSB. Warranty coverage limits are determined by the identified causal part.
OPERATION
DESCRIPTION
TIME
092205A
2008-2009 Ranger: Follow
0.3 Hr.
Service Procedure To
Adjust And Grease The
Glass Run On One (1)
Door (Do Not Use With
Any Other Labor