Ranger 2WD V6-3.0L (2008)
Parking Brake Control: Service and Repair
Parking Brake Control
Parking Brake Control
Removal and Installation
1. NOTE: Make sure the parking brake control is fully released.
Release the parking brake cable tension.
2. Disconnect the front parking brake cable from the parking brake intermediate cable at the cable union.
3. Compress the clip and separate the front parking brake cable from the frame bracket.
4. Remove the 2 parking brake release handle bolts.
5. Disconnect the parking brake signal switch electrical connector.
6. Remove the 3 parking brake control bolts.
^
To install, tighten to 20 Nm (15 lb-ft).
7. Disconnect the front parking brake cable from the parking brake control.