Ranger 2WD V6-3.0L (2008)
Condenser HVAC: Service and Repair
CONDENSER CORE
Removal and Installation
NOTE:
-
If a condenser core leak is suspected, the condenser core must be leak-tested before it is removed from the vehicle.
-
Installation of a new suction accumulator is not required when repairing the air conditioning system, except when there is physical evidence of
system contamination from a failed A/C compressor or damage to the suction accumulator.
All vehicles
1. Recover the refrigerant.
2.3L and 4.0L vehicles
2. Remove the air cleaner outlet tube.
2.3L vehicles
3. Remove the compressor-to-condenser line fitting nut and disconnect the fitting.
-
Discard the O-ring seal.
-
To install, tighten to 8 Nm (71 lb-in).
All vehicles
4. Remove the condenser outlet fitting nut and disconnect the fitting.
-
Discard the O-ring seal.
-
To install, tighten to 8 Nm (71 lb-in).
5. Remove the condenser inlet fitting nut and disconnect the fitting.
-
Discard the O-ring seal.