Ranger 2WD V6-3.0L (2008)
Air Flow Meter/Sensor: Service and Repair
MASS AIR FLOW (MAF) SENSOR
Removal and Installation
1. Disconnect the mass air flow (MAF) sensor electrical connector.
2. Remove the 2 bolts, the MAF sensor and discard the gasket.
-
To install, tighten to 11 Nm (8 lb-ft).
3. CAUTION: Do not tamper with the mass air flow (MAF) sensing elements located in the airflow bypass. Tampering may result in
failure.
NOTE: The MAF sensor module and body are calibrated and installed as a unit.
To install, reverse the removal procedure.
-
Install a new gasket.