Ranger 2WD V6-3.0L (2008)
Transmission Speed Sensor: Service and Repair
Output Shaft Speed (OSS) Sensor
Output Shaft Speed (OSS) Sensor
Output Shaft Speed (OSS) Sensor
Removal
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the output shaft speed (OSS) sensor electrical connector.
3. Remove the OSS sensor screw.
4. Remove the OSS sensor from the transmission.
Installation
1. NOTE: Inspect the OSS sensor O-ring for damage. If damaged, install a new O-ring Inspect and lubricate the O-ring with petroleum jelly.
Install the OSS sensor into the transmission.
2. Install the OSS sensor screw.
^
Tighten to 10 Nm (89 lb-inch).
3. Connect the OSS sensor electrical connector.