Ranger 2WD V6-3.0L (2008)
Installation
1. CAUTION: The lube hole in the extension housing bushing must be aligned with the lube groove in the extension housing. This groove is
located at the 3 o'clock position when viewed from the rear. Failure to align the bushing can result in bushing damage.
NOTE: Inspect the counterbore of the extension housing for burrs. Remove any burrs from the extension housing counterbore with an oil stone.
Position the extension housing bushing into the extension housing.
2. NOTE: The tool will bottom when bushing is in the correct position.
Using the special tool, install the extension housing bushing.
3. Position new extension housing seal with drain hole in the 6 o'clock position.