Ranger 2WD V6-3.0L (2008)
21. NOTE: Always install the bearing caps in their original locations and positions.
NOTE: Apply pressure toward the left side to make sure the LH differential bearing cup seats correctly.
Install the LH bearing cap and loosely install the 2 bolts.
22. Install progressively larger differential bearing shims on the RH side until the largest shim is installed by hand.
23. Install the right side bearing cap and 2 bolts. Tighten the 4 LH and RH bearing cap bolts.
^
Tighten to 112 Nm (83 lb-ft).
24. Rotate the differential carrier several times to verify the differential bearings have seated correctly.
25. Install the special tools and measure the ring gear backlash.
^
If the backlash is within specification, proceed to Step 28.
^
If a zero backlash condition occurs, proceed to Step 26.
^
If the backlash is not within specification, proceed to Step 27.