Ranger 2WD V6-3.0L (2008)
33. Apply marking compound and rotate the differential assembly 5 complete revolutions.
34. Verify an acceptable pattern check.
35. Install the axle shafts.
36. Position the driveshaft and align the index marks on the pinion flange.
37. NOTE: The driveshaft centering socket yoke fits tightly on the pinion flange pilot. To make sure that the driveshaft centering socket yoke seats
squarely on the pinion flange, tighten the driveshaft flange bolts evenly in a cross pattern.
Install the 4 driveshaft flange bolts.
^
Tighten to 112 Nm (83 lb-ft).
Ford 8.8-Inch Ring Gear - Rear Drive Axle/Differential
Differential Ring And Pinion