Ranger 2WD V6-3.0L (2008)
32. Apply marking compound and rotate the differential assembly 5 complete revolutions.
33. Check for an acceptable pattern.
34. Install the axle shafts.
35. Position the driveshaft and align the index marks on the pinion flange.
36. CAUTION: The driveshaft centering socket yoke fits tightly on the pinion flange pilot. To make sure that the driveshaft centering socket
yoke seats squarely on the pinion flange, tighten the driveshaft flange bolts evenly in a cross pattern or damage to the component may
occur.
Install the 4 driveshaft flange bolts.
^
Tighten to 103 Nm (76 lb-ft).
Ford 8.8-Inch Ring Gear High Torque - Rear Drive Axle/Differential
Differential Ring And Pinion