Ranger 2WD V6-3.0L (2008)
2. Disconnect the battery ground cable.
-
To install, tighten to 9 Nm (80 lb-in).
3. Disconnect the windshield wiper motor electrical connector.
4. Position the PCM connector and harness aside.
1
Loosen the bolt.
2
Remove the nut and stud.
-
Disconnect the PCM electrical connector and position the harness aside.
5. Remove the RH access cover.
1
Remove the screws.
2
Remove the access cover.
6. Reach through the RH access cover opening and remove the wiper motor clip from the RH mounting arm and pivot shaft.