Ranger 2WD V6-3.0L VIN U (1998)
6. Remove the pads and the stainless steel slippers.
1
Remove the pads.
2
Remove the stainless steel slippers.
7. Measure the front disc brake hub and rotor for minimum thickness.
-
Replace the front disc brake hub and rotor if not within specification.
8. If necessary, resurface the front disc brake rotor. Ford recommends on-vehicle rotor machining. Follow the lathe manufacturer's instructions.
9. Inspect the disc brake caliper for leaks.
-
If leaks are found, disassembly is required.
INSTALLATION
1. Install the stainless steel slippers and the pads.
1
Install the stainless steel slippers.
2
Install the pads.
NOTE:
-
Clean the anchor plate and stainless steel slipper surfaces.
-
The inboard pad has a wear indicator tab.