Ranger 2WD V6-3.0L VIN U (1998)
Seat Belt Height Adjuster: Service and Repair
Shoulder Safety Belt Height Adjuster With Stripped Weld Nuts
1. Remove the quarter trim panel.
2. Use the drill provided in the D-Ring Installation Kit to drill out the damaged threads in the upper pillar structure.
3. Apply a suitable lubricant to the tap provided in the D-Ring Installation Kit and tap new threads.
NOTE: After each rotation, back off tap slightly to remove new cuttings and be sure to blow out any chips before proceeding.
4. Use a threaded insert provided in the D-Ring Installation Kit and screw it into the retapped hole until it is slightly below the surface.
5. Use a hammer to lightly tap the installation tool provided in the D-Ring Installation Kit several times to seat the insert keys.
NOTE: If the two bolts on the height adjuster are not stripped, refer to Height Adjuster. If the bolts are stripped, replace the height adjuster.
6. Install the quarter trim panel.
^
Check for proper operation.