Ranger 2WD V6-3.0L VIN U (1998)
7. Remove and discard the forward clutch piston seals.
1. Remove the forward clutch piston inner seal.
2. Remove the forward clutch piston outer seal.
-
Inspect the forward clutch piston for cracks.
8. Inspect the following forward clutch drum assembly:
1. Inspect the forward clutch cylinder surfaces for scores or burrs. Minor scores or burrs may be removed with a crocus cloth. Replace the
forward clutch cylinder if it is badly scored or damaged.
2. Inspect forward clutch piston for scores or burrs. Minor scores or burrs may be removed with a crocus cloth. Replace forward clutch cylinder if
it is badly scored or damaged.
3. Inspect the check ball.
9. Make sure the check ball is free and clear of debris, has freedom of movement, and is properly seated.
-
Inspect clutch plate serration for scores or burrs.
-
Inspect fluid passages for obstructions. Clean out all passages.
-
Inspect forward clutch piston bore for scores and replace if necessary.
-
Inspect the friction clutch plates, steel clutch plates and clutch pressure plate for worn or scored bearing surface. Replace all parts that are
deeply scored.
-
Check clutch plates for flatness and fit on the clutch hub serrations. Discard any plate that does not slide freely on the serrations or that is not
flat.
-
Check clutch hub thrust surfaces for scores and clutch hub splines for wear.
-
Inspect for damage or wear to the clutch disc grooves and retaining ring grooves.
-
Inspect for damage to the needle bearing and seal rings.
NOTE: The check ball is located in the piston.
ASSEMBLY
1. Thoroughly clean all parts in solvent and blow dry with moisture free compressed air.
2. Install new forward clutch piston seals.
1. Install the forward clutch piston inner seal.
