Ranger 2WD V6-3.0L VIN U (1998)
Extension Housing: Service and Repair
EXTENSION HOUSING GASKET
REMOVAL
1. Disconnect the battery ground cable.
2. Raise and support the vehicle.
3. Mark the rear driveshaft.
NOTE: To maintain initial driveshaft balance, mark the rear driveshaft yoke and axle flange so they may be installed in their original position.
4. Remove the rear driveshaft.
1. Remove the rear driveshaft bolts.
2. Remove the rear driveshaft.
5. Remove the transmission mount nuts.