Ranger 2WD V6-3.0L VIN U (1998)
-
If MINIMAL contamination is present, drain the transmission fluid, replace the Extension Housing (F2TZ-7A039-A), use Ford-approved RTV
sealant: F7TZ-19554-AA (or equivalent meeting Ford specification ESB-M4G92-A) and refill with MERCON(R)V Automatic Transmission Fluid
(XT-5-QM).
SCENARIO # 2:
If extension housing bushing IS NOT in the proper location within the bore., replace the Transmission (MF87A-7003-CA).
d.
AUTOMATIC AND MANUAL TRANSMISSIONS CONTINUED:
-
Install a new driveshaft and make sure that the driveshaft and axle alignment marks are aligned. Refer to Parts Block for proper driveshaft usage.
-
Fill transmission fluid to the proper level using MERCON(R)V Automatic Transmission Fluid (XT-5-QM).
-
Replace the PCM. For proper removal and installation procedures, refer to your appropriate Ranger Workshop Manual. Refer to chart for proper
PCM usage.
4.
Road test vehicle to verify repair.
