Ranger 2WD V6-3.0L VIN U (1998)
3. Remove the rear driveshaft.
1. Remove the bolts.
2. Remove the rear driveshaft.
4. Use Seal Remover and Impact Slide Hammer, and remove the extension housing seal.
CAUTION: Use the extension housing bushing remover carefully so that the seal area is not damaged.
5. Remove extension housing bushing.
1. Install Extension Housing Bushing Remover.
2. Remove extension housing bushing.
INSTALLATION
1. Position the extension housing bushing into the extension housing.
CAUTION: The lube hole in the extension housing bushing must be aligned with the lube groove in the extension housing. This groove is located
at the 3 o'clock position when viewed from the rear.
