Ranger 2WD V6-3.0L VIN U (1998)
INSTALLATION
1. Align the flats of the manual valve inner lever with the flats on the manual control lever shaft. Install the manual valve inner lever and parking
lever actuating rod onto the manual control lever shaft.
CAUTION: Make sure the parking lever actuating rod is correctly seated into the case parking rod guide cup. Verify that the output shaft is
locked in the PARK position.
2. Install the manual valve inner lever nut.
CAUTION: Do not bend the manual valve inner lever pin.
3. Install the manual valve detent spring.
4. Clean the extension housing and install new extension housing gasket. Make sure that the parking pawl is correctly installed.