Ranger 2WD V6-3.0L VIN U (1998)
5. Remove the fluid pump gears and front pump adapter plate.
NOTE:
-
A rough casting on the pump surface crescent is not a flaw.
-
The fluid pump gears are part of the pump assembly and are not serviced separately.
6. Remove the drive gear O-ring and discard. Inspect the fluid pump gears for cracks and scoring. Replace front pump support and gear assembly if
damaged.
7. Inspect front pump.
1. Inspect the front pump support gear pockets for scoring and wear.
2. Clean and inspect the front and rear input shaft bushings.
8. Inspect the fluid pump adapter plate for scoring and wear.
9. Inspect the fluid pump-to-converter housing bushing and converter hub-to-converter housing seal. Replace converter housing assembly if
necessary.
