Ranger 2WD V6-3.0L VIN U (1998)
Transmission Mount: Service and Repair
REMOVAL
1. Disconnect the battery ground cable.
NOTE: 4x2 procedure shown. 4x4 similar, front drive shaft will need to be removed.
2. Raise and support the vehicle.
3. Mark the rear driveshaft.
NOTE: To maintain initial driveshaft balance, mark the rear driveshaft yoke and axle flange so they may be installed in their original positions.
4. Remove the rear driveshaft.
1. Remove the bolts.
2. Remove the rear driveshaft.
5. Remove the nuts.