Ranger 2WD V6-3.0L VIN U (1998)
2. Install clutch master cylinder tube.
1. Position line and install roll pin.
2. Tug on clutch master cylinder tube.
3. Raise and support the vehicle.
4. Bleed the system.
5. Insert the male coupling end into the female coupling of the clutch slave cylinder.
-
Check that the connection is secure by applying a slight tug to the line.
NOTE: Check that the 0-ring is in place on the line. Check the clutch slave cylinder port to be sure there is no O-ring.
6. Connect the line to the plastic clip on the floor flange.
7. Lower the vehicle.