Ranger 2WD V6-3.0L VIN U (1998)
16. Measure the differential case runout without the ring gear. Check the case runout again with the new differential bearings. If the runout is now
within the specification shown, use the new differential bearings for assembly. If the runout is still excessive, the differential case is damaged and
must be replaced.
17. Remove differential case from the rear axle housing.
INSTALLATION
1. Press a new anti-lock speed sensor ring, if removed, and the ring gear on the differential case.
2. Install the ring gear bolts.
-
Apply Stud and Bearing Mount EOAZ-19554-BA or equivalent meeting Ford specification WSK-M2G349-A1 to the ring gear bolts.
3. With pinion depth set and pinion installed, place the differential case in the rear axle housing.