Ranger 2WD V6-4.0L (2010)
Radio/Stereo: Service and Repair
Satellite Digital Audio Receiver System (SDARS) Module
Satellite Digital Audio Receiver System (SDARS) Module
Removal and Installation
1. NOTE: Module configuration is required when a new Satellite Digital Audio Receiver System (SDARS) module is being installed.
Upload the SDARS module configuration information to the scan tool. For additional information, refer to Programmable Module Installation
(PMI) in Information Bus. See: Powertrain Management/Computers and Control Systems/Information Bus/Service and Repair
2. Lower the glove compartment completely.
3. Disconnect the satellite antenna cable and the SDARS module electrical connector.
4. Remove the 3 nuts.
-
To install, tighten to 8 Nm (71 lb-in).
5. Remove the 3 J-studs and the SDARS module.
6. To install, reverse the removal procedure.
-
Download the SDARS module configuration information to the scan tool. For additional information, refer to PMI in Information Bus. See:
Powertrain Management/Computers and Control Systems/Information Bus/Service and Repair