Ranger 2WD V6-4.0L (2010)
8. Correctly route the backrest latch release cable as noted during removal and install the pin-type retainer.
9. Install the seat track. For additional information, refer to Seat Track - Bucket and 40 Percent See: Seat Track/Service and Repair/Seat Track -
Bucket and 40 Percent.
10. Route and attach the wire harness.
11. Install the seat cushion cover. If a passenger seat has been serviced, do not prove out the Supplemental Restraint System (SRS) at this time.
For additional information, refer to Seat Cushion Cover - Front See: Seat Cover/Service and Repair/Seat Cushion Cover - Front.
12. For passenger seat, carry out the Occupant Classification Sensor (OCS) System Reset. For additional information, refer to the General Procedures
portion of Restraint Systems.