Ranger 2WD V6-4.0L (2010)
Tailgate Latch: Service and Repair
Tailgate Latch Remote Control
Tailgate Latch Remote Control
Removal and Installation
1. Remove the 8 screws and the tailgate access cover.
-
To install, tighten to 5 Nm (44 lb-in).
2. Open the tailgate latch actuating rod retainers and disconnect the tailgate latch actuating rods from the tailgate latch remote control.
3. Remove the 2 tailgate latch remote control nuts.
-
To install, tighten to 12 Nm (106 lb-in).
4. Remove the tailgate latch remote control.
5. NOTE: Prior to installation, remove the slack in the tailgate latch release links by pulling the tailgate latch release links to the center of the tailgate
. Close the plastic clip over the thread of the tailgate latch release links.
To install, reverse the removal procedure.