Ranger 2WD V6-4.0L (2010)
Steering Angle Sensor: Service and Repair
Steering Wheel Rotation Sensor
Removal and Installation
1. Remove the steering column opening trim panel.
1. Remove the 2 screws.
2. Remove the trim panel.
2. Remove the steering column opening cover reinforcement.
1. Remove the 5 bolts.
-
To install, tighten the steering column opening cover reinforcement bolts to 8 Nm (71 lb-in).
2. Remove the reinforcement.
3. Disconnect the steering wheel rotation sensor electrical connector and remove the connector and retaining pin from the instrument panel frame.
4. Remove the 2 bolts and the steering wheel rotation sensor.