Ranger 2WD V6-4.0L (2010)
14. If necessary adjust the right rear parking brake shoes. See Figure 11.
1. Using a suitable brake adjusting gauge measure the inside diameter of the drum portion of the rear brake disc. Record the measurement.
2. Using a suitable brake adjusting gauge set the parking brake shoe diameter to 0.5 mm (0.020 in.) less than the inside diameter of the drum
portion of the rear brake disc.
15. Install the brake disc. For additional information refer to the WSM Section 206-04.
16. Install the wheel and tire assembly.
^
Tighten the wheel nuts in a star/cross pattern to 135 Nm (100 lb-ft).
17. With the help of an assistant release the parking brake cable tension by pulling down on the intermediate cable at the cable-to-cable connector clip
until the parking brake control sector rotates to its stop and remove the previously installed retainer pin.
18. Check the parking brake system for correct operation.
