Ranger 2WD V6-4.0L (2010)
Removal and Installation
1. Detach the accelerator cable from the Throttle Body (TB) and the accelerator cable bracket.
2. Detach the exhaust manifold-to-EGR valve tube from the EGR valve.
-
To install, tighten to 34 Nm (25 lb-ft).
3. Disconnect the Evaporative Emission (EVAP) purge valve-to-intake manifold tube from the intake manifold.
4. Detach the EVAP purge valve-to-intake manifold tube retainer.
5. Disconnect the differential pressure feedback EGR sensor electrical connector.
6. Detach the wiring harness retainer from the differential pressure feedback EGR sensor.
7. Remove the differential pressure feedback EGR sensor.
8. Disconnect the Camshaft Position (CMP) sensor electrical connector.
9. Disconnect the EGR vacuum regulator solenoid electrical connector.
10. Disconnect the EGR vacuum regulator solenoid vacuum connector.
11. Remove the 2 bolts and the EGR vacuum regulator solenoid.
-
To install, tighten to 10 Nm (89 lb-in).
12. Disconnect the wiring harness electrical connectors.