ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 2224 > < Initial Inspection and Diagnostic Overview|Page 2222
Page 26
background image

 

NOTE:  When re-running the network test, the network test application must be first closed or the screen display reverts back to the prior run network
test results.

-

Disconnect: SJB Fuse 8 (10A).

-

Enter the following diagnostic mode on the scan tool: Network Test.

-

Repeat the network test.

-

Do all other modules pass the network test?

Yes

INSTALL the removed fuse. GO to H12.

No

INSTALL the removed fuse. An intermittent fault is not present. GO to Pinpoint Test A.  See: Pinpoint Test A: The PCM Does Not Respond To The
Scan Tool

-------------------------------------------------
H12 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE OCSM DISCONNECTED

 

NOTE:  When re-running the network test, the network test application must be first closed or the screen display reverts back to the prior run network
test results.

-

Disconnect: Occupant Classification System Module (OCSM) C3159.

-

Enter the following diagnostic mode on the scan tool: Network Test.

-

Repeat the network test.

-

Do all other modules pass the network test?

Yes

CONNECT the OCSM. GO to Pinpoint Test B.  See: Pinpoint Test B: The Occupant Classification System Module (OCSM) Does Not Communicate
With the Scan Tool

No

CONNECT the OCSM. GO to Pinpoint Test C.  See: Pinpoint Test C: The Restraints Control Module (RCM) Does Not Respond To The Scan Tool

-------------------------------------------------

 

Pinpoint Test I: No High Speed Controller Area Network (HS-CAN) Communication, All Modules
Are Not Responding

Communications Network

Pinpoint Test

Pinpoint Test I: No High Speed Controller Area Network (HS-CAN) Communication, All Modules Are Not Responding

Refer to wiring Diagram Set 14, Module Communications Network for schematic and connector information.

Refer to wiring Diagram Set 25, Electronic Engine Controls - 4.0L for schematic and connector information.

Normal Operation

The High Speed Controller Area Network (HS-CAN) uses an unshielded twisted pair cable.

This pinpoint test is intended to diagnose the following:

-

Fuse

-

Wiring, terminals or connectors

Initial Inspection and Diagnostic Overview|Page 2224 > < Initial Inspection and Diagnostic Overview|Page 2222