Ranger 2WD V6-4.0L (2010)
Communications Control Module: Service and Repair
Audio Unit Shipment Mode
Audio Unit Shipment Mode
Entering Shipment Mode
NOTICE: The CD6 audio unit must be placed in shipment mode anytime the audio unit is removed (including for diagnostic purposes). Failure
to follow this instruction may result in damage to the audio unit.
NOTE: This procedure applies to the CD6 audio unit.
1. Turn the audio unit on and eject any CDs loaded in the audio unit.
2. Turn the key to OFF.
3. Press and hold presets 2 and 5, simultaneously.
4. While holding the presets, turn the key to ACC or RUN.
-
The audio display flashes SHIPMENT.
-
When the CD tray has parked, the audio unit displays SHIPMENT ON.
5. Turn the key to OFF.
6. Remove the audio unit. For additional information, refer to Audio Unit See: Accessories and Optional Equipment/Radio, Stereo, and Compact
Disc/Radio/Stereo/Service and Repair/Audio Unit.
Exiting Shipment Mode
NOTE: If the audio unit is removed, install the audio unit before beginning this procedure.
1. Turn the key to ACC or RUN.
2. Turn the audio unit on.
3. Press and hold the LOAD button for approximately 2 seconds.
-
The audio unit enters loading mode, at which time the shipment mode is exited.
4. Turn the audio unit off.
