Ranger 2WD V6-4.0L (2010)
4. NOTE: Slight clockspring rotor turning is allowed for steering column alignment.
Install the clockspring.
-
With the flats of the clockspring aligned to the flats of the steering column, slide the clockspring on the steering column.
-
Engage the upper and side tabs.
5. Engage the lower clockspring clip.
6. Connect the clockspring electrical connectors.
-
Install the ground wire.
-
Connect the electrical connectors and attach the pin-type retainers.
7. Position the upper steering column shroud.
8. Position the lower steering column shroud and install the 3 screws.
9. Install the tilt release lever/handle.
10. Install the steering column opening cover reinforcement and 4 bolts.
-
Tighten to 8 Nm (71 lb-in).
11. Align the lower steering column opening trim panel and push in, seating the clips and install the 2 screws.
12. Position the hood release handle and install the 2 screws.
13. Install the ignition lock cylinder. For additional information, refer to Doors, Hood and Trunk &/or Locks.
14. NOTE: Make sure the wheels are in the straight-ahead position.