Ranger 2WD V6-4.0L (2010)
3. Remove the nut and safety belt buckle pretensioner.
-
To install, tighten to 40 Nm (30 lb-ft).
4. To install, reverse the removal procedure.
5. Install the seat. For additional information, refer to Seats.
6. Check the active restraint system for correct operation. For additional information, refer to Safety Belt System. See: Testing and Inspection
Safety Belt Buckle and Pretensioner - 40 Percent
Safety Belt Buckle and Pretensioner - 40 Percent
NOTE: RH shown, LH similar.
Removal and Installation
WARNING: After any crash, all of the following safety belt assemblies and attaching hardware must be inspected by an authorized dealer to
verify correct function:
-
Retractors
