Ranger 2WD V6-4.0L (2010)
5. Disconnect the pressure line-to-pump fitting.
-
To install, tighten to 75 Nm (55 lb-ft).
6. Compress the clamp and disconnect the power steering pump supply hose from the power steering pump.
7. Remove the 3 bolts and the power steering pump.
-
Tighten to 25 Nm (18 lb-ft).
8. NOTICE: A new Teflon(R) seal must be installed any time the pressure line is disconnected from the power steering pump or a fluid leak
may occur.
To install, reverse removal procedure.
-
Using the Teflon(R) Seal Installer Set, install a new Teflon(R) seal on the pressure line-to-pump fitting.
9. Fill the power steering system. For additional information, refer to Steering.