Ranger 2WD V6-4.0L (2010)
Universal Joint: Service and Repair
Driveshaft Universal Joint - Single Cardan, Flange Yoke
Driveshaft Universal Joint - Single Cardan, Flange Yoke
Disassembly
Initial disassembly
1. NOTICE: Do not, under any circumstance, clamp the driveshaft in the jaws of a vise or similar holding fixture. Denting or localizing
fracture may result, causing driveshaft failure during vehicle operation.
NOTICE: Because the driveshaft is precisely balanced, even a slight dent can cause noise and vibration.
Place the driveshaft on a suitable workbench. Do not damage the tube.
2. Index-mark the driveshaft components.
3. Remove and discard the 4 snap rings.
4. Clamp the C-Frame and Screw Installer/Remover in a vise.
Bearing cup removal
5. NOTE: If necessary, use a pair of pliers to remove a bearing cup that fails to press out all the way.
Remove the bearing cups and the flange.
1. Position the flange in the C-Frame and Screw Installer/Remover.
