Ranger 4WD L4-122 2.0L SOHC (1984)
11.
Grind or block sand the area down to correct contour. Grind with a #240 Disc followed by #320 Wetordry paper followed by #400
Wetordry paper.
NOTE:
Sanding in two directions tends to lift edges and spoil the appearance.
12.
Examine the finish sanded service and fill any bubbles, holes or low spots with additional adhesive filler.
NOTE:
Spot or glazing putty cannot be used for Elastomeric (flexible) urethane plastic part servicing.
13.
The entire panel surface must be scuff-sanded (orbital type disc or block) with #320 Disc or paper.
14.
Clean area by blowing off with an air gun. (Filtered dry air).
