Ranger 4WD L4-122 2.0L SOHC (1984)
Obtain an Authorized Modifications decal and list the date, dealer number and summary of alterations performed. Select a prominent place adjacent to
the Vehicle Emission Control Information decal suitable for installing the Authorized Modifications decal. Clean the area, install the decal and cover it
with a clear plastic decal shield.
PART NUMBER
PART NAME
CLASS
E4TZ-9D474-C
Solenoid Vacuum Valve
C
E4TZ-9E724-C
Throttle Module Wiring Assy.
C
33795-S7
Nut
BG
DOPZ-12226-B
Vacuum Hose 5/32" I.D.
AG
387065-S
Plastic Elbow
BR
95874-S
Bundling Strap
AG
E3TZ-9A758-E
Accelerator Cable Assy.
C
E3TZ-9728-G
Kickdown Bellcrank
C
OTHER APPLICABLE ARTICLES: None
WARRANTY STATUS: Reimbursable within the provisions of the Warranty and Policy Manual.
OPERATION: SP9758A84 - Replace accelerator cable
TIME:
0.3 Hr.
OPERATION: SP9758B84 - Replace accelerator cable and bellcrank
TIME:
0.5 Hr.
OPERATION: SP9758C84 - Replace accelerator cable - install throttle module wiring assy. and replace throttle kicker.
TIME:
0.8 Hr. DLR. CODING: Basic Part No. DRIVE Code: F4
Technical Service Bulletin # 84329
Date: 840131
Fuel/Ignition - Cold Start Stall/Stumble
Article No. 84-3-29
STALL/STUMBLE (2.0L) - COLD START - MANUAL TRANSMISSION - CALIBRATION 3-41S-R18
LIGHT TRUCKS 1984 RANGER
CALIBRATION: 3-41S-R18
FIGURE 37
Vehicles with the subject calibration may experience stumbles and/or stall conditions during the cold drive mode. To resolve this concern, perform the
following:
Check engine ignition timing and idle speeds. If they are not to specification, change as required. With engine idle and timing set to specification, change
the choke setting from one notch rich to two notches rich by removing the grey index plate and replacing it with a yellow index plate E3PZ-9A539-A.