Ranger 4WD L4-122 2.0L SOHC (1984)
^
Remove the R.H. windshield wiper linkage cover (see Ranger/Bronco II Truck Shop Manual, 35-60-14 Figure 10) to allow access to install the
screens.
^
Insert the R.H. screen into the cowl, making sure that the orientation of the screen mesh is the same as the cowl grille.
^
Tie the screen up into place under the cowl grille, using as many tie wires as necessary to secure the screen.
^
Mix a small portion of the two-part epoxy and put a drop in at least 4 places on each grille bar, making sure that the screen wire is completely
covered at each point of attachment.
^
Repeat the process on the L.H. grille opening, making sure the epoxy is completely hardened before releasing the tie wires.
^
Reinstall the access cover and release the vehicle.
PARTS REQUIRED (Procure Locally)
Hardware Cloth Two-Part Epoxy Wire Ties Touch-Up Paint
OTHER APPLICABLE ARTICLES: None
WARRANTY STATUS: Reimbursable within the provisions of the Warranty and Policy Manual.
OPERATION: M
TIME:
"Actual Time" as defined in the Warranty and Policy Manual. DLR. CODING: Basic Part No. 7002010 Code: 49