Ranger 4WD L4-134 2.2L DSL (1983)
Figure 8
2.
Loosen bolts A & B to finger tight, and position the transfer case shift lever to the 4L position (lever down as shown by arrow in Figure 8).
3.
Move the cam plate rearward until the bottom chamfered corner of the neutral lug just contacts the forward right edge of the shift lever (see point
C in Figure 8).
4.
Holding the cam plate in this position, torque bolt A first to 70-90 ft.lbs., and then bolt B to 31-42 ft.lbs.
5.
Move the transfer case in-cab shift lever to all shift positions to check for positive engagement. There should be clearance between the shift lever
and cam plate in the 2H front, 4H rear (clearance not to exceed .13 inch), and 4L rear shift positions.
6.
Install shifter boot assembly.
