Ranger 4WD L4-140 2.3L VIN A EFI (1997)
Band Apply Servo: Service and Repair
Intermediate and Overdrive Servos
REMOVAL
NOTE: Procedures are the same for both O / D and intermediate servos.
1. Remove heat shield, if equipped.
NOTE: Catalytic converter(s) may have to be removed.
2. Install Servo Cover Compressor T95L-77028-A over the intermediate servo cover at the fluid pan rail with tool stamping facing up. Tighten the
screws.
CAUTION: Servo is under spring tension. Use caution when removing.
NOTE: The J-hook must be in the appropriate hole for the servo being removed.
3. Using a 1/2-inch wrench, tighten the nut on the J-hook until there is a gap between the servo cover and the snap ring.
4. Carefully remove the servo cover retaining ring.
CAUTION: The servo cover is under spring tension.
5. Carefully back off the nut on the J-hook until the servo spring is unloaded.