Ranger 4WD L4-153 2.5L SOHC VIN C SFI (2001)
Parking Brake Cable: Service and Repair
Cable and Conduit - Rear
Cable and Conduit - Rear
Removal
1. NOTE: Make sure the parking brake control is fully released.
Relieve the tension on the parking brake system.
1
Pull down on the front parking brake cable and conduit.
2
Insert a 4 mm (5/32-inch) drill bit or equivalent retainer.
2. Raise and support the vehicle.
3. Remove the tire and wheel assembly.
4. NOTE: Disconnect the parking brake intermediate cable from the locating hole end of the connector.
Disconnect the parking brake intermediate cable from the LH parking brake rear cable and conduit.